Ensuring You Have Correct Measurements
Place a tape measure on a bed or the floor. Lie on top of the tape adjusting if necessary so that the tape is at the level of your stoma/hernia.
Lie flat on your back on the tape measure. Wait about 3-5 minutes allowing the hernia to recede. Sometimes it doesn’t go much flatter.
Put tape measure across your abdomen for the correct length measurement. Write it down.
To find the width of the hernia support, measure from the top of the hernia to the bottom. Assuming the hernia is around the stoma this will be the width of the belt required. The width might be 6” up to 12” depending on the size of the hernia in relation to the location of the stoma. Write it down.
For the opening to pull the pouch through the measurement needs to be specific.
- For a two piece measure across the opening on the barrier/flange to the outside of the plastic neck that attaches the pouch. Add ¼” to that measurement. Write it down.
- One piece depends a lot on the manufacturer. Keeping in mind that the pouch should lay flat on the hernia support measure across the flange. This can be tricky. Some manufacturers have a blue line around the flange; this would be your measurement across the flange from blue line to blue line.
Wearing Your New Hernia Support
Put the Hernia Support Belt under your body at the level of your stoma.
Lay down to allow the hernia to recede.
Put your pouch through the opening.
Fasten the Velcro closing. Support should be snug but not too tight as you want your stoma to work efficiently.
Now stand up. You should feel supported but not uncomfortable.
Questions, Comments or Concerns
If any of this is confusing, feel free to call Rosemarie at 1-866-856-5088 and she will be happy to explain anything further to ensure you get the best fit possible!